Products

Features and Benefits:

• Operates at a stand-off distance of 1/4", +/- 3/16" to accommodate plate variations.
  
• Optional height sensor is available to maintain the recommended stand-off distance. (NOTE: sensor does not work with standing water on piece to be cut)
  
• High Carbon Steel marking pin has a diameter of .25" for robust marking
  
• Marking Pin is easy to remove to replace

Two modes of operation are normally associated with the Pneumatic Punch Marker:

Center punch for drilled hole location - Using the machine control, the punch is properly positioned using offset commands. The depth of the punch can be controlled using the dwell command for a punch up to .01".

Scribe lines for secondary operations - Marks for weldments, bend lines, or assembly locations can be created using a high frequency function for the reciprocating pin (9000BPM). The Marker moves along a pre-programmed path, and depending on speed chosen, will create a line or a series of dots.

The Pneumatic Punch Marker is available on the EdgeMate, EdgeMaster, MPC2000, Titan II, and TMC4500ST machine models.